RunSIMPLIS

Runs the SIMPLIS simulator. Note that you must have a SIMetrix/SIMPLIS license for this command to work.

The RunSIMPLIS command will not pre-process the netlist. This must be done separately using the PreProcessNetlist command.

RunSIMPLIS [/fresh] [/append] [/label division-label] [/sweep start|continue|finish] [/checkAbort] filename

Parameters

/append

Append data to current group. Otherwise creates a new data group.

/checkAbort

Instructs SIMPLIS to check abort requests.

/fresh

Instructs SIMPLIS to run simulation afresh and not to use any state information saved from previous runs.

/label

Used with /sweep to name the division of a linked run

/sweep

Used for multi-step runs. See Run command above for details.

Notes

RunSIMPLIS is the primitive SIMetrix command that launches SIMPLIS. However, when running a simulation on a schematic, a number of other activities are performed. These include pre-processing the netlist generated by the schematic editor and also resolving a trigger device for POP analysis. If you wish to simulate a schematic in exactly the same manner as the Run menu, you need to execute the script simplis_run. This simulates the currently open schematic. The full source for simplis_run can be found on the install CD.