|
|
Runs the SIMPLIS simulator. Note that you must have a SIMetrix/SIMPLIS license for this command to work.
The RunSIMPLIS command will not pre-process the netlist. This must be done separately using the PreProcessNetlist command.
| RunSIMPLIS [/fresh] [/append] [/label division-label] [/sweep start|continue|finish] [/checkAbort] filename |
|
/append |
Append data to current group. Otherwise creates a new data group. |
|
/checkAbort |
Instructs SIMPLIS to check abort requests. |
|
/fresh |
Instructs SIMPLIS to run simulation afresh and not to use any state information saved from previous runs. |
|
/label |
Used with /sweep to name the division of a linked run |
|
/sweep |
Used for multi-step runs. See Run command above for details. |
RunSIMPLIS is the primitive SIMetrix command that launches SIMPLIS. However, when running a simulation on a schematic, a number of other activities are performed. These include pre-processing the netlist generated by the schematic editor and also resolving a trigger device for POP analysis. If you wish to simulate a schematic in exactly the same manner as the Run menu, you need to execute the script simplis_run. This simulates the currently open schematic. The full source for simplis_run can be found on the install CD.
|
|
||