3.3  Viewing the Output Report

During each test, DVM measures scalar data, such as the converter phase margin, and compares these scalar results with the specifications stored in the DVM control symbol. Each test is assigned a PASS/ FAIL status based on these comparisons. If the same tests were selected as in the example, the overview report should show one test failure due to the minimum phase-margin specification. In the image below, the overview report has been annotated to highlight the common data elements of the overview report.

Report	Legend
	Schematic used for this report Testplan from which this report was generated Note: This contains the complete testplan, not just the selected tests. Report directory The overview log file in text format with information about each run Number of tests run, the number of passed tests, etc. Tab separated text files with measured scalars and evaluated specs Links to the individual test reports

For this example, the first Bode plot test at light load failed the minimum phase margin test specifications. The test report shows that the simulated phase margin of 16.92 degrees was below the specification value of 35 degrees set in the DVM control symbol with annotations noted below.

Report	Legend
	Report file - a text version of this report containing information about all scalars and graphs Screen capture of the schematic just before the simulation executed Pass/Fail Status Input deck file on which the simulation was run Measured scalars Measured specs Graph Data