Wire Command

Enter schematic wiring mode.

Wire [/start] [/loc <x1> <y1> <x2> <y2>] [/mode] [/startloc <x1> <y1>]



If specified, command in non-interactive and wire is placed at location specified by x1 y1 x2 y2. Co-ordinates are relative and would usually be derived from a call to WirePoints .


If specified, the schematic editor is placed in a temporary wiring mode. The next left click will start a wire and wiring may proceed in the usual manner. After pressing the right mouse button, wiring mode will be cancelled.


If specified, a new wire is started.